| |
 |
Major
Features
- Simultaneous full duplex 2 Gb/s Fibre
Channel delivers up to 400 MB/s
- Automatic speed negotiation
- Full fabric support using F_Port and FL_Port
connections
- On board hardware context cache for superior
fabric performance
- Support for concurrent use of multiple
protocols (SCSI, IP)
- Full support for FC service Class 2 and 3
- Support for FC-Tape (FC-2) devices
- 64-bit, 66 MHz low profile or standard short
form factor PCI
- End-to-end parity protection for high data
integrity
- Buffered data architecture to support up to
50 km cabling at full 2Gb/s bandwidth
- Robust suite of software including IP and
storage protocols under Windows 2000, Windows
NT, HP-UX, Linux, NetWare, Solaris and AIX
- Optical small form factor (LC) interface
supports either short-wave or long-wave optics
|
|
Description
The LightPulse™ LP9002L Fibre Channel PCI
host adapter provides support for 2 Gb/s fibre
channel data rates, delivering the industry's
highest performance. The LP9002L features
automatic speed negotiation capability which
allows complete compatibility with existing 1 Gb/s
Fibre Channel SANs, while allowing seamless
upgrades to higher speed 2 Gb/s SANs.
The LP9002L provides the flexibility and broad
interoperability needed for complex highly
scalable SANs. The LP9002L provides a unique
combination of features, including switched fabric
support using F_Port and FL_Port connections,
full-duplex data transfers, high data integrity
features, support for all Fibre Channel topologies
and support for service class 2 and 3.
The LP9002L also features sophisticated
hardware that provides superior performance in
storage area networks, delivering low latency and
high throughput in switched, arbitrated loop and
clustered environments. Support for fiber optic
cabling is provided through a small form factor
(LC) optical embedded interface.
Driver Support
The LP9002L is complemented by a rich suite of
software support including storage protocol
(SCSI), network protocol (IP) as well as
concurrent multi-protocol (SCSI & IP)
operation, enabling advanced storage area network
(SAN) implementations in Windows 2000, Windows NT,
HP-UX, Linux, NetWare, Solaris and AIX
environments. All drivers are also fully
compatible with the Emulex LP9000, LP8000,
LP7000E, LP952L and LP850 host bus adapters.
|
|
|
Standards
ANSI
Fibre Channel FC-FS
ANSI Fibre Channel FC-PH/PI
ANSI Fibre Channel FC-AL
ANSI Fibre Channel FC-PLDA
ANSI Fibre Channel FC-FLA
PCI Local Bus Revision 2.2 (see power
requirements)
PHP Hot plug - Hot swap
Fibre Channel Class 2, 3
Architecture
Emulex
Centaur ASIC technology
up to 66 MHz PCI bus master DMA
2 Gb/s or 1 Gb/s FC Link
2 MB FLASH memory
1 MB code RAM
256 KB buffer RAM
Software Environments
Windows
2000
Windows NT
HP-UX
Linux
NetWare
Solaris
AIX
Hardware Environments
x86,
SPARC, PowerPC and Alpha
PCI hardware platforms
3.3 or 5V tolerant signaling
Optical
| Data
Rates: |
1.0625/2.125
Gb/s |
| Optics: |
short/long
wave lasers |
| Cable: |
9/125
µm single-mode fiber |
| |
50/125
µm multi-mode fiber |
| |
62.5/125
µm multi-mode fiber |
| Connector
Type: |
LC |
| Distance
(1 Gb/s) |
10K
meters (32,800') 9/125 µm fiber |
| |
500
meters (1640') 50/125 µm fiber |
| |
300
meters (984') 62.5/125 µm fiber |
| Distance
(2 Gb/s) |
10K
meters (32,800') 9/125 µm fiber |
| |
300
meters (984') 50/125 µm fiber |
| |
150
meters (492') 62.5/125 µm fiber |
|
Physical Dimensions
Short
low profile MD2 form factor
low profile or standard bracket
167.64mm x 64.42mm
(6.60" X 2.54")
Power Requirements
| Volts: |
+3.3
VDC +/- 5% |
| Power |
8.5
watts typical |
Environmental Conditions
| Operating
Temperature: |
0°
to 45° C (32° to 113° F) |
| Airflow
Required: |
10
Lf/m |
| Storage
Temperature: |
-40°
to 70° C (-40° to 158° F) |
| Relative
Humidity: |
5%
to 95% non-condensing |
Agency Approvals
Class
1 Laser Product per DHHS 21CFR (J)
and EN60825 |
| UL
Recognized to UL 1950 |
| CUR
Recognized to CSA22.2, No. 950 |
| TUV
Certified to EN60950 |
| FCC
Rules, Part 15, Class A |
| ICES-003,
Class A |
| EMC
Directive 89/336/EEC (CE Mark) |
| -
EN55022, Class A |
| -
EN55024 |
| Australian
EMC Framework (C-Tick Mark) |
| -AS/NZS
3548, Class A |
| VCCI,
Class A |
|
Ordering Information
| LP9002L-F2 |
Embedded
multi-mode optic interface (LC) |
| LP9002L-X2 |
Embedded
long wave optic interface (LC) |
|
|
|
|
|
|